原因は特定できない。不良（変形）ポテンシャルとしては１．成形直後～梱包

原因は特定できない。
不良（変形）ポテンシャルとしては
１．成形直後～梱包前までの山積み
２．梱包
３．寸法小
４．経時変化

４．は継続評価中だが、可能性のある1～3を対策。
但し３．はこれからなので修正、try、評価までの日程を良く確認し
記載して下さい。

あとは、
根本原因対策でなく流出対策として専用治具でのヘタリ確認。

以上元になったデータは整理してあるので
自分の中で話が理解できていれば回答はすぐできるはずです。

Kết quả (Anh) 1:

Unable to determine the cause.As a potential defects (deformed)1. Immediately after molding to pile up before packaging2. Packing3. Size small4. Time variation4. Is 1's ongoing evaluation of the possibility to measure out 3.However, 3... Is so it better verify the fix, try the evaluation date andPlease describe.After that,Instead of root cause prevention, leakage prevention as SAG confirmation in a special jig.Because it is more organized dataIn understanding the story answers should be soon.

Kết quả (Anh) 2:

Cause can not be identified.
As bad (deformation) potential
1. Pile of before - just after molding packaging
2. Packing
3. Size Small
4. Change over time

4. It ongoing evaluation is, possible measures 1-3.
However 3. Fix because it now, try, well to check the dates of up to evaluation
should be described.

After that,
worn confirmation of a dedicated jig as spill response rather than the root cause measures.

Or more since the data became original are organized
answer if you understand the story in their own should be able to soon.

Kết quả (Anh) 3:

The cause can not be specified.Bad (deformation) and potential1. Before and immediately after molding packing pile2 PackSmall size 3.4. ChangeThe evaluation of the countermeasure in one to three possible.However, because the future, try to make a good evaluation programmePlease.After theIn the root cause and preventive measures of the spill response without a dedicated jig buckling.Based on the above data is organizedI will reply you soon talk can be realized.